Storage impulsive processes in the merging phase space

The storage impulsive processes given by a sum of random variables on a superposition of two renewal processes are considered on increasing time intervals. The averaging, diffusion approximation, and large deviation problem are studied in the series scheme with a small parameter series under suitable scaling.     

Energy‐resolved electron‐yield XAS studies of nanoporous CoAlPO‐18 and CoAlPO‐34 catalysts

Energy‐resolved electron‐yield X‐ray absorption spectroscopy is a promising technique for probing the near‐surface structure of nanomaterials because of its ability to discriminate between the near‐surface and bulk of materials. So far, the technique has only been used in model systems. Here, the local structural characterization of nanoporous cobalt‐substituted aluminophosphates is reported and it is shown that the technique can be employed for the study of open‐framework catalytically active systems. Evidence that the cobalt ions on the surface of the crystals react differently to those in the bulk is found.     

Ultra-stable microwave generation with a diode-pumped solid-state laser in the 1.5-μm range

We demonstrate the first ultra-stable microwave generation based on a 1.5-μm diode-pumped solid-state laser (DPSSL) frequency comb. Our system relies on optical-to-microwave frequency division from a planar-waveguide external cavity laser referenced to an ultra-stable Fabry–Perot cavity. The evaluation of the microwave signal at ~10 GHz uses the transportable ultra-low-instability signal source ULISS^®, which employs a cryo-cooled sapphire oscillator. With the DPSSL comb, we measured ?125 dBc/Hz phase noise at 1 kHz offset frequency, likely limited by the photo-detection shot-noise or by the noise floor of the reference cryo-cooled sapphire oscillator. For comparison, we also generated low-noise microwave using a commercial Er:fiber comb stabilized in similar conditions and observed >20 dB lower phase noise in the microwave generated from the DPSSL comb. Our results confirm the high potential of the DPSSL technology for low-noise comb applications.     

Effect of Anchimeric Assistance in the Reaction of Triphenylphosphine with α,β‐Unsaturated Carboxylic Acids

Quaternization of triphenylphosphine with maleic and cis‐aconitic acids is strongly accelerated by participation of the cis‐carboxyl group in stabilization of the phosphonium zwitterion intermediate by intramolecular hydrogen bonding, in spite of steric hindrance by the acid's reaction center. A similar effect for trans‐isomeric acids is not observed, which can be rationalized on the basis of spatial structures of the generated zwitterions, implying an electrostatic interaction between the phosphonium center and carbonyl oxygen atom. The effect of anchimeric assistance decreases when the intramolecular hydrogen bonding disfavors attack of the phosphine on the sterically less hindered carbon atom of the C=C bond, as observed for cis‐aconitic acid.     

Nanostructured Pt supported on cocoon-derived carbon as an efficient electrocatalyst for methanol oxidation

Development of suitable supports has been proven as an important preparation process for high active catalysts of fuel cell. In this work, a carbon material was prepared by pyrolyzing cocoons with ferric chloride as activator, and then Pt nanoparticles (ca. 50 wt.%) were deposited on its surface. The characteristics of X-ray diffraction and transmission electron microscopy showed that the face-centered cubic structured Pt nanoparticles with nano-sized crystals interconnected each other via grain boundaries were formed on the surface of pyrolyzed cocoons. Afterwards, electrochemical results demonstrate that the nanostructured Pt supported on this support exhibits higher catalytic activity and CO tolerance than Pt nanoparticles supported on Vulcan carbon for methanol oxidation reaction.     

In memoriam: Boris Dubrovin

Letters in Mathematical Physics -